Humilis white gold bracelet with diamonds

How to Take Measurements

1. Get a flexible measuring tape.
2. Ring Diameter:
   • Place the tape measure over the ring at the center and measure the maximum inside width of the ring.
   • Check the corresponding size in the measurement table.
3. Finger circumference:
   
   • Wrap the finger with the measuring tape and position it at the widest part of your finger.
   • Read the circumference measurement.
   • Check the corresponding size in the measurement table. We recommend choosing the largest size if the circumference is between two sizes.
4. Wrist circumference:
   
   • Wrap the wrist with the measuring tape and tighten it as far as it will comfortably go.
   • Read the circumference measurement.
   • For a correct fit of our bracelets it is important to always add 1 cm to the measurement result.
   • Check the corresponding size in the measurement table.

Download the size chart ->

1.  These are often sold in craft stores
2. Neck:
   • Measure around the base of the neck in inches.
   • Round up to the nearest half inch.
3. Chest:
   • Wrap tape measure under armpits around fullest part of chest (usually right above nipples
4. Sleeve:
   • Bend your elbow and rest your hand on your hip.
   • Have someone measure from the middle of the back of your neck to your wrist by putting the tape measure over your shoulder, around your elbow and to your wrist.
5. Waist:
   • Wrap tape measure around where you normally wear your pants. Keep tape measure a little loose by keeping a finger between the tape measure and your waist.
6. Inseam:
   • Put on a pair of shoes.Have someone measure from your crotch to back of the heel, where you want your pants to end.
7. Hands:
   • Measure around the hand at the fullest part (exclude thumb). The number of inches shows the size of the glove.

Download the size chart ->